2017-04-01 Erik Andresenamcl tuning
2017-04-01 Erik AndresenIncrease inflation for global costmap a bit
2017-03-26 Erik Andreseninverse value for pitch_handicap_strength
2017-03-24 Erik Andresenreenabled motor handicap and made parameters configurea...
2017-03-12 Erik Andresenadded hector, cartographer launch
2017-02-23 Erik Andresenadded needed includedirs for catkin on kinetic
2017-02-04 Erik Andresenamcl tuning
2017-01-28 Erik AndresenTrajectoryPlanner & gmapping tuning
2017-01-23 Erik Andresenconfiguration of odometry covariance via dynamic reconf...
2017-01-23 Erik Andresenupdated razor imu config
2017-01-20 Erik Andresenadded power_consumption.txt
2017-01-20 Erik Andresenupdated pid values ods
2017-01-20 Erik Andresenupdated motor pid values
2017-01-16 Erik Andresenavr/motor_ctrl: set avr frequency to 5MHz
2017-01-14 Erik Andresenavr/motor_ctrl: Disable pwm output on value 0 to avoid...
2017-01-07 Erik Andresentune slam gmapping
2016-12-29 Erik AndresenSensor.msg: use float for pressure
2016-12-28 Erik Andresenadded sensor msg and script
2016-12-27 Erik Andresenadded pyshared submodules, use i2c from pyshared
2016-12-26 Erik Andresenfix simulation
2016-12-05 Erik AndresenMerge branch 'master' of ssh://vontaene/home/erik_alt...
2016-12-05 Erik Andresen-reenable range layer
2016-11-20 Erik Andresen-reenable range layer
2016-11-18 Erik AndresenMerge branch 'master' of ssh://vontaene/home/erik_alt...
2016-11-18 Erik Andresen-added dynamic reconfiguration for wt_node
2016-10-30 Erik Andresenumbmark: use absolute position
2016-10-28 Erik AndresenMerge branch 'master' of ssh://vontaene/home/erik_alt...
2016-10-28 Erik Andresenwild_thumper.launch: do not respawn on error...
2016-10-28 Erik Andresenpid tuning data
2016-10-28 Erik Andresenmotor_ctrl: pid tuning
2016-10-28 Erik Andresenmotor_ctrl: tune odometry from umbmark
2016-10-23 Erik Andresenfrontier exploration fixes
2016-10-01 Erik Andresenexploration tuning
2016-09-06 Erik Andresenmotor_ctrl: break when going to fast
2016-08-30 Erik Andresenpid tuning for gear ratio=1:47
2016-08-14 Erik Andresenuse esum to stop motor when stalling to avoid damage
2016-08-13 Erik Andresenfix angle velocity
2016-07-16 Erik Andresenpid tuning with fixes
2016-07-16 Erik Andresenpid fixes
2016-07-13 Erik Andresenmotor_ctrl: pid tuning data and added helper script
2016-07-13 Erik Andresenmotor_ctrl: pid tuning
2016-07-13 Erik Andresenmotor_ctrl: migrate to 4x VNH2SP30
2016-05-01 Erik AndresenRevert "Transision from 4x TLE5205 to 2x VNH2SP30"
2016-05-01 Erik AndresenRevert "wt_node: Transision from 4x TLE5205 to 2x VNH2SP30"
2016-04-18 Erik Andresenwt_node: Transision from 4x TLE5205 to 2x VNH2SP30
2016-04-16 Erik AndresenTransision from 4x TLE5205 to 2x VNH2SP30
2016-04-01 Erik Andresendwa planner tuning tle5205
2016-04-01 Erik Andresenfix motor direction after error state
2016-03-31 Erik Andresenaddded script to get motor step response
2016-03-31 Erik Andresenmotor_ctrl: pid tuning
2016-03-25 Erik Andresenmotor_ctrl: handle tle error state
2016-02-21 Erik Andresennavigation stack tuning
2016-02-20 Erik Andresenmoved cfg-files to config
2015-12-29 Erik Andresenadded basic pocketsphinx launch file
2015-12-28 Erik Andresenwait 3s for ros to register and establish all subscribe...
2015-12-28 Erik Andresenwild_thumper.launch: make wt_node required
2015-12-28 Erik Andresen3dsensor: use rosparam to set depth mode
2015-12-23 Erik Andresenmotor_ctrl: do handicap on both directions
2015-12-23 Erik Andresenwt_node: no asynci2c access on cmd_vel
2015-12-23 Erik Andresen3dsensor: enable hw processing
2015-12-18 Erik Andresenavr/motor_ctrl: lower Brown out level to 2.7V
2015-12-18 Erik Andresenminor fixes
2015-12-06 Erik Andresenadded rgb stripes
2015-10-17 Erik Andresenrobot_pose_ekf: use vo for gps input as it will work...
2015-10-15 Erik Andresensonar sensors: set fov to 40° as stated in picaxe.hobbi...
2015-10-12 Erik Andresenekf: gps fixes
2015-10-11 Erik Andresennano: provide wrf read only values
2015-10-11 Erik Andresen-navigation stack fixes
2015-09-27 Erik Andresenenabled range sensor layer
2015-09-24 Erik Andresenumbmark correction
2015-09-22 Erik Andresenavr: calibration from umbmark
2015-09-22 Erik Andresenmove_base: don't launch mapserver if nomap is set
2015-09-06 Erik Andresenadded, tested with simulation
2015-09-06 Erik Andresenwild_thumper.launch: add joint_state_publisher
2015-09-03 Erik Andresensimulation/gazebo: added controller for imu, range...
2015-09-03 Erik Andresenadded gazebo simulation
2015-08-26 Erik Andresencut 6wd model to 4wd
2015-07-23 Erik Andresen3dsensor: reduce depth resolution
2015-07-19 Erik Andresenadded waypoint script
2015-07-19 Erik Andresenrazor.yaml: new calibration
2015-07-18 Erik Andresenadded gpsd client
2015-07-11 Erik AndresenMerge branch 'master' of ssh://vontaene/home/erik_alt...
2015-07-11 Erik Andresenadded move_base
2015-07-11 Erik Andresenrenamed to
2015-07-11 Erik Andresennew magnetometer calibration
2015-07-10 Erik Andresenavr/nano: move avcc as adc reference
2015-07-10 Erik Andresenmove_base: calib ir sensors
2015-07-10 Erik Andresenadded range sensor messages
2015-08-14 Erik Andresenodometry tuning
2015-08-14 Erik Andresenadded robot_pose_ekf
2015-08-14 Erik Andresenurdf: fix elements rotation
2015-06-14 Erik Andresenavr/motor_ctrl: odom fixes
2015-06-13 Erik Andresenadded 3dsensor
2015-06-13 Erik Andresenavr/motor_ctrl: handicap fixes
2015-06-13 Erik Andresenavr/motor_ctrl: handicap: sep forward, backward
2015-06-06 Erik Andresenset tle error flags high
2015-06-05 Erik Andresenavr/motor_ctrl: fix angle reading
2015-06-05 Erik AndresenMerge branch 'master' of ssh://vontaene/home/erik_alt...
2015-06-05 Erik Andresenmove_base: use imu to control motor handicap
2015-08-14 Erik Andresenrazor: new magnetometer calibration